Or if there are lots of holes between the house and the attic warm moist air can rise into the attic from the house.
Admitting air into the attic.
If you have air admittance valves in the attic and they fail to close then it is always possible that the air handler can draw in the sewer gases as they escape and distribute them through the house.
In order to accomplish this an adequate venting system must be in place to vent the roof by allowing air flow to enter through soffit intake vents and out through ridge vents gable vents or louver vents.
Cold air doesn t hold as much moisture so it condenses on the roof deck.
In these rare cases plumbers use an air admittance valve.
Air admittance valves aka studor vents are negative pressure activated one way mechanical valves.
If a bath fan dumps into the attic that is very warm very moist air entering a cold space.
Hot air exhaust vents located at the peak of the roof allow hot air to escape.
It may seem counterproductive to go to the trouble of improving attic insulation only to then add vents that admit outside air into the attic but fresh air plays a vital role in roof health.
By admitting outside air into the attic as warmer air leaves the attic through higher vents soffit vents play a major role in effective roof ventilation.
Outlet vents allow the air to escape from your attic and are installed at a higher elevation.
Air from the living space below can carry water vapor into the attic hitting a cold place in the attic and causing rot and mold growth.
These vents are installed directly into the blocking between the exposed rafters.
Gable end vents installed near the peak of a gable end this screened vent can allow hot air to leave the attic or fresh air to enter depending on prevailing breezes and temperature conditions.
Attic air may contain contaminants including mouse droppings fiberglass asbestos and mold.
Used most commonly at an island sink or vanity the vents are also located in the attic to prevent the roof penetrations as seen above on the front roof line elevation.
Intake vents located at the lowest part of the roof under the eaves allow cool air to enter the attic.
This prevents cold outside air from traveling through the attic and into the living area of the home.